METAL COCKRING

Jump to newest

By (user no longer on site) OP
over a year ago

how do I get the correct size ring can anyone help ???

Reply privately

Reply in forum

Reply +quote

By *ancNickMan
over a year ago

Stockport

Have you already had it done if not they will pierce it with a 2.4 mm ring then when goes loose round the hole stretch up is easy... Then decide if want a ring or a bar ring you want bout enough clearance to make a perfect loop hole to hole... Bar depends on length of piecing prob usually 12-16mm length wildcat is good place for rings and bars.... Also if decide on a princes wand make sure you get correct lengths

Reply privately

Reply in forum

Reply +quote

By (user no longer on site)
over a year ago

wouldn't rubber be safer? never had one before, will have to have a look at that length wildcat.

Reply privately

Reply in forum

Reply +quote

By (user no longer on site)
over a year ago

Go on the love honey site they have a video and write. Guide for them

Reply privately

Reply in forum

Reply +quote

By *oodmessMan
over a year ago

yumsville

I recently asked and its near impossible to get a size guide. I think its trial and error though I recently tried a very hard rubber one with pretty much no give.. 3 different sizes - the biggest was too lose and the smaller ones I couldnt get on.

They look good but I think it'd cost to get the one that fits right

Reply privately

Reply in forum

Reply +quote

By *ancNickMan
over a year ago

Stockport

Rubber noooo talking dryness an friction burns are you mad.... If want light weight get niobium or ptfe plastic

Reply privately

Reply in forum

Reply +quote

By *ancNickMan
over a year ago

Stockport

Try searching sincentral part of wildcat or if want proper crazy shit look up MrBs or MasterBs they have some mega mad stuff

Reply privately

Reply in forum

Reply +quote

By (user no longer on site) OP
over a year ago

thanks guys

Reply privately

Reply in forum

Reply +quote

Post new Message to Thread