Join us FREE, we're FREE to use
Web's largest swingers site since 2006.
Already registered?
Login here
![]() | Back to forum list |
![]() | Back to The Lounge |
Jump to newest | ![]() |
Reply privately | Reply in forum | Reply +quote |
| |||
Reply privately | Reply in forum | Reply +quote |
| |||
Reply privately | Reply in forum | Reply +quote |
"Did the replacement hard drive have an operating system on it already?" Yes... | |||
Reply privately | Reply in forum | Reply +quote |
| |||
Reply privately | Reply in forum | Reply +quote |
"Ok guys.....thanx!!! Iv obviously messed somethin else up....will have another go... Cath xx" Check the "jumpers" on the back of the hard drive to see if they are set to the same as the one you took out e.g. "master" or "cable select" etc - It could be that | |||
Reply privately | Reply in forum | Reply +quote |
| |||
Reply privately | Reply in forum | Reply +quote |
Reply privately | Reply in forum | Reply +quote |
" I removed my hard drive and replaced it with another (from dif computer)...do I need a reboot disc?? I have tried looking for advice online, but it goes way over my head :o( " Was the hard drive you replaced it with from a PC with only one hard drive in it, or two? If it was two then the new hard drive may have been configured to be a slave (you can tell by the way the jumpers are set). There will be a jumper on two pins with another pin not used. You move the jumper so it occupies the middle pin and the one that wasn't used. If the new hard drive was the only drive in the pc you got it from then you may have to put it back in the pc you took it from and format the drive. Then put it in the pc you want to use and reinstall your operating system. | |||
Reply privately | Reply in forum | Reply +quote |
![]() ![]() | |||
Reply privately | Reply in forum | Reply +quote |
" I removed my hard drive and replaced it with another (from dif computer)...do I need a reboot disc?? I have tried looking for advice online, but it goes way over my head :o( Was the hard drive you replaced it with from a PC with only one hard drive in it, or two? If it was two then the new hard drive may have been configured to be a slave (you can tell by the way the jumpers are set). There will be a jumper on two pins with another pin not used. You move the jumper so it occupies the middle pin and the one that wasn't used. If the new hard drive was the only drive in the pc you got it from then you may have to put it back in the pc you took it from and format the drive. Then put it in the pc you want to use and reinstall your operating system." Don't go formatting the hard drive if it worked in the old PC it should work in the other one too, after checking the jumper settings on the drive itself that is and not all jumper settings are the same for all hard drives. You may need to let windows load drivers for the different hardware e.g. motherboard, etc but only format the drive as a last resort. ![]() | |||
Reply privately | Reply in forum | Reply +quote |
Post new Message to Thread |
back to top | ![]() |