FabSwingers.com mobile

Join us FREE, we're FREE to use

Web's largest swingers site since 2006.

Already registered?
Login here

Back to forum list
Back to The Lounge

Casting nipples to make pewter Cufflinks

Jump to newest
 

By (user no longer on site) OP   
over a year ago

This is a project I'm retrying from a year ago, last time I used liquid latex to make the original mould, this time I'm using alginate moulding powder. Much easier to make, it has reduced the original moulding time from one hour to less than 3 minutes.

Has anyone else made any casts of any naughty parts. I've got a clone a willy kit but I've struggled to get a good mould, i keep getting a massive air bubble at the hilt.

Reply privatelyReply in forumReply +quote
 

By (user no longer on site)
over a year ago

try vibrating the mold to get rid of any air in the mold

Reply privatelyReply in forumReply +quote
 

By (user no longer on site)
over a year ago

Wouldn't the cufflinks be too far apart to be of much use in fastening shirt cuffs?

Even then, would they fall out in warmer weather.

Reply privatelyReply in forumReply +quote
 
 

By (user no longer on site)
over a year ago

try getting out more

Reply privatelyReply in forumReply +quote
Post new Message to Thread
back to top